We like to pretend that wires are perfect all the time. For the most part that’s acceptable, but sometimes you really do care about those tiny fractional ohm quantities. Unfortunately though, most meters won’t read very low values. There are tricks you can use to achieve that aim, such as measuring low currents through a device with a known voltage applied. It is handier though to have an instrument to make the reading directly, and [Kasyan TV] did just that with a surprisingly low part count.
The whole thing is built from an LM317, a resistor, and a voltmeter module, that’s it. [Kasyan] mentions the meter’s accuracy means the lower digits are not meaningful, but it looks to us as though there are other sources of error — for example, there’s no way to zero out the probe’s resistance except during the initial calibration.
This isn’t going to be perfect — you’d do better with a 4-wire measurement and a way to zero set shorted probes. However, it does seem to work well enough and it is a simple, but useful, project.
Our favorite quote is this one:
The case itself was printed on a 3D printer. It turned out ugly and not neat, but I don’t care much.
Sounds like a good way to think about it.
We’ve seen homemade meters like this before, but they were more complicated. We’ve even seen them cobbled together which is fine if you don’t care much.
This product has always been on my wishlist due to its High-resolution results. I can quickly note low resistance measurements. The results of milliohm meter are very accurate, which is rarely seen. The best part is it's handy and durable too.
ReplyDeleteI got it with CE Certification, and the accessories included 4-wire cables with Kelvin clip connectors. The instrument also has a manual zero display. I got it online from the Omni Controls Inc. website. The package came within the specified time limit. Their services are quite good.